SITE INTELLIGENCE

Start with a parcel

Search for an address, or zoom in and select a parcel.

The map uses real Vicmap data.
Zoom to street level to explore parcels, roads and trees.

Nearby radius

CONCEPT STUDIO

Residential layout

Geometric and spatial screening only, not a complete compliance assessment. Setbacks and development limits are editable assumptions pending verified planning rules.

SUBDIVISION LAYOUT

Design mode

Housing typeArrangementDwelling countTarget floor area / dwelling · m²Front setback / mRear setback / mLeft setback / mRight setback / mInternal driveway width / mMaximum site coverage / %Minimum reserved green / %Open space / dwelling · m²Maximum storeysPrefer same storeys (allow unequal lot areas)Frontage edge (-1 = infer)

Setbacks apply to building walls relative to the original parcel boundary, not private lot boundaries or foundations. For three-home battle-axe layouts, the two rear homes have no front setback from internal access. Battle-axe buildings follow the envelope where feasible, with total floor area set by the target (including garage). Internal driveway width controls both arms of the L-shaped shared access. Editable concept assumptions. Frontage shown in orange; edge indices start at 0. Apartments share one site and building; dwelling count is not a subdivision count. Green includes open space and excludes driveways. House / townhouse: 3 × 6 m single garage; facade width > 8 m uses a 6 × 6 m double garage. Townhouses have no internal side setback. Target floor area includes garage.

Width / mDepth / mStoreysStorey height / mUniform setback / mRotation / °East–west offset / mNorth–south offset / m

Building footprint

Click at least three points on the map, then drag vertices to adjust. Move on map applies to rectangular and L-shaped footprints.

Simulate overriding constraints (conflicts remain visible)

Hover over a tree to remove it. Click “Restore tree” at its original location to include it in the plan again. Tree changes regenerate the design.

MAP EXPLORER

Map layers

Zoom in to reveal parcels, then buildings, trees and addresses. Dense layers wait until you zoom in further. Layer choices stay enabled while their detail is hidden. These switches control Vicmap detail; the street, park and ocean basemap stays visible.

Terrain

Loading map…

Parcel Trees Design Conflicts / constraints Approved easement Proposed easement

© State of Victoria · Vicmap | G-NAF © Geoscape Australia
10 m DEM: indicative terrain. Missing data does not establish absence.